Show me pics of your lazy eyed FC's!!
#1
‘88 GTU
Thread Starter
Show me pics of your lazy eyed FC's!!
If you wouldn't mind. Caught in between doing it and not, if anyone has a stock s5 (turbo II) bumper that would be great. I've seen lots with AM bumpers and it looks cool, but with stock bumpers is what I'm unsure about really.
Thanks
Thanks
#6
Full Member
iTrader: (2)
Here's mine:
http://www.youtube.com/watch?v=bWRwLdb_Y4A
I don't really care what anyone says... it can look good on certain FCs. In my case I have TSX HID retros so it doesn't kill my light output at all.
http://www.youtube.com/watch?v=bWRwLdb_Y4A
I don't really care what anyone says... it can look good on certain FCs. In my case I have TSX HID retros so it doesn't kill my light output at all.
Trending Topics
#8
Slowpoke
iTrader: (3)
i think those are too high . they gotta be low
Only looks good tho when car has other visual mods, looks horrible on a stock car.
Used to do it on my 240sx, it really looks better on that car than it does on fc imo, the design of the headlight covers goes past the hood http://a2.sphotos.ak.fbcdn.net/hphot..._6959215_n.jpg
But i did try it on the FC a couple years back, wasnt too crazy about it
Only looks good tho when car has other visual mods, looks horrible on a stock car.
Used to do it on my 240sx, it really looks better on that car than it does on fc imo, the design of the headlight covers goes past the hood http://a2.sphotos.ak.fbcdn.net/hphot..._6959215_n.jpg
But i did try it on the FC a couple years back, wasnt too crazy about it
#10
‘88 GTU
Thread Starter
Hypertek - looks better lower, i think your right.
#15
Full Member
iTrader: (1)
I disagree. When its too low it makes it look like the headlight covers are not aliened properly (like the white one ^) I think you need to be able to see a little headlight, but in all honesty I think it looks stupid on 99% of cars in general. I've always been a fan of the "clean" look, I don't even like to open my sun roof because it breaks up the body lines lol.
#21
Senior Member
iTrader: (5)
Join Date: May 2010
Location: crater on mars
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
my old fc =[
sleepy
you can also use the gap, from the sleepy eyed position, to suck in cold air into the engine bay. there is about a half inch gap if you remove the rubber molding on the hood.
sleepy
you can also use the gap, from the sleepy eyed position, to suck in cold air into the engine bay. there is about a half inch gap if you remove the rubber molding on the hood.
Last edited by NatAsRex7; 08-23-11 at 08:48 PM.