Post pics of your engine bay
#1076
For maximum response (assuming you dont have an AFM issue etc that requires a BOV) the best position for a BOV is in the trash can, as contrary to popular myth, turbo rpm drops far faster with the BOV open than without (try it with a turbo speed sensor if you don't believe me...).
#1077
Do you have anymore info on your intercooler/rad setup? looks really clean. did u have to cut up anything or did u just get brackets to make the system work. Also i love the look of the overflow tank, anymore info on that too?
#1078
Full Member
iTrader: (4)
Join Date: Jun 2006
Location: Austell GA
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
The rad is a koyo n-flow. The intercooler is from cxracing. The expansion is form rotary works (one of the worst fitting pieces I have come across). I had to cut out the round tube from the front cross member and fab up the brackets to fit everything.
#1092
NA-BOOSTIN
We'll grabbed a few shots since I was in the bay finishing wiring .the battery and main fuse block relocated to the bin behind the seats . Chassis harness also tucked . Sorry for the crappy phone pics. Getting a new dslr camera this weekend since the wife drop the last one .
#1094
Junior Member
#1096
NA-BOOSTIN
Yup it is sir . Outside like stated before and In the bay . Need to touch up a few spots from banging the intercooler piping an turbo like a dumbass . But for he most part it's really forgiving when banging **** around . The outside I have no problems at all but it was a different kit . Plan on doing the lower section inside and remove the carpet from the bins forward .
#1099
NA-BOOSTIN
I like how you wrapped the pipes in heat wrap . I've did that to my tbss and dropped a couple degrees on iat . Was thinking to do the same on my pipes . Down for more pics