NACA duct
#1
NACA duct
I recently did some intercooler charge pipes on my car. I moved the AFM to the driver side, and was left with a lot of room infront of the turbo. I happened to have a NACA duct sitting around the house. So I jumpped in and started cutting. After cutting the hole out, I started to feel bad about cutting a mint aluminum hood, but it was too late.
I think it turned out ok.
I think it turned out ok.
Trending Topics
#13
Got the afm adapter from the pull-part. It was just laying on the ground.
2in hot pipe, 2.5in cold pipe. I don't like doing anything that can]t be undone, so I ran the pipes between the body and radiator. Also using a stock top mount in the front (its pink).
If you didn't know, its a six-port setup.
2in hot pipe, 2.5in cold pipe. I don't like doing anything that can]t be undone, so I ran the pipes between the body and radiator. Also using a stock top mount in the front (its pink).
If you didn't know, its a six-port setup.
#14
Rotary Enthusiast
iTrader: (8)
Got the afm adapter from the pull-part. It was just laying on the ground.
2in hot pipe, 2.5in cold pipe. I don't like doing anything that can]t be undone, so I ran the pipes between the body and radiator. Also using a stock top mount in the front (its pink).
If you didn't know, its a six-port setup.
2in hot pipe, 2.5in cold pipe. I don't like doing anything that can]t be undone, so I ran the pipes between the body and radiator. Also using a stock top mount in the front (its pink).
If you didn't know, its a six-port setup.