Crown Victoria rim request
#101
Freshly Built Streetport
Join Date: May 2010
Location: Minneapolis, Minnesota
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Thanks philstar. I'll be going the Tanabe GF210 route with the KYB AGX shocks, so with 205/50's up front I think I'll need to get an adjustable camber plate and with 225/45's in the rear I'll get a rear camber adjuster to get it to sit right without rubbing.
#103
My job is to blow **** up
iTrader: (8)
NOT EXACT but pretty ******' close.
225(width) 45(ratio) 16 rim size(duh?)
so a 205 with 50 will have a 205*50=102.5 side wall height
but. a 245 with 50 would be 245*50=122.5 side wall height
..................................so a 245*45=110.25 side wall
245*40=98
98 would be smaller, so we settle with slightly taller rears.
for kicks and giggles 315*30 110.25 205*55 112.75
#104
Freshly Built Streetport
Join Date: May 2010
Location: Minneapolis, Minnesota
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Not trying to turn this into a tire thread, but after I posted that I did some more reading and realized the profile difference is tiny like you said. Here's a good page with tire size info...
http://www.fc3spro.com/TECH/MODS/RT/tires.htm
http://www.fc3spro.com/TECH/MODS/RT/tires.htm
#105
Full Member
Join Date: Mar 2011
Location: Chicago, IL
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
I ended up getting them through RHDJapan, pricey but it was the easiest way for me to get them and they came in less than a week =)
#107
Full Member
Join Date: Mar 2011
Location: Chicago, IL
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
and yes I do, although I am part of a separate drift crew, my previous car might look familiar if you follow those guys at all
http://i294.photobucket.com/albums/m...a6831d81_o.jpg
#110
Freshly Built Streetport
Join Date: May 2010
Location: Minneapolis, Minnesota
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Finally found a set after a month of searching. They'll need to be sandblasted and painted as they've suffered from many years of Minnesota winters and salt.
It'll be a bit til I can get them redone, but they can sit in my garage for the time being.
It'll be a bit til I can get them redone, but they can sit in my garage for the time being.
#114
Freshly Built Streetport
Join Date: May 2010
Location: Minneapolis, Minnesota
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
@ JustJeff, my last set of rims were 5Zigen FN01R-C's and even with those the center caps wouldn't fit up front due to the size of the dust cap. I've talked to a few FC owners who don't run center caps for the same reason. I'm sure you can find someone who could put a rotor or mazda emblem on the end of the ford/mercury center caps with a vinyl sticker. That is, if they fit over the front dust cap. But you can kind of see in my pic above that the caps are 2-3 inches tall and stick out a bit past the face of the rim which I think de-emphasizes how deep dish they are
#115
Just bought all four plus tires 205/60/16 for 100 bucks lol..
later gonna put some 205/40/16 in the front
225/45/16 in the back lol later though not worried about it since my 7 isn't running
later gonna put some 205/40/16 in the front
225/45/16 in the back lol later though not worried about it since my 7 isn't running
#117
Apex Seal Treachery!!!!!!
iTrader: (13)
@ JustJeff, my last set of rims were 5Zigen FN01R-C's and even with those the center caps wouldn't fit up front due to the size of the dust cap. I've talked to a few FC owners who don't run center caps for the same reason. I'm sure you can find someone who could put a rotor or mazda emblem on the end of the ford/mercury center caps with a vinyl sticker. That is, if they fit over the front dust cap. But you can kind of see in my pic above that the caps are 2-3 inches tall and stick out a bit past the face of the rim which I think de-emphasizes how deep dish they are
#118
Senior Member
#119
Freshly Built Streetport
Join Date: May 2010
Location: Minneapolis, Minnesota
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
@JustJeff: Right after I say I'd doubt the dust caps fit, my friend spots this car at a local meet I was unable to attend last night. Looks like these particular center caps do fit. And of course my car looks almost the same as this guys' NA as mine is a black TII with spoiler, luckily I'm going to be painting my vics a different color. As a disclaimer, I have no idea who owns this car and I'm just posting it for demonstrational purposes. If you're on RX7club, your car looks great
Last edited by TIIFC3S; 05-01-12 at 10:41 AM.