Gauge cluster swap Pins again S4 wires to S5 cluster
#26
Like Ghandi with a gun
Join Date: Mar 2003
Location: Rapid City, SD
Posts: 4,584
Likes: 0
Received 0 Likes
on
0 Posts
Anyone know which wire/pin is the oil gauge behind the dash? I need to run a new wire for it but don't know which on eit is on the dash... FSM page no?
EDIT: found on another page, can anyone confirm the red/yellow wire is oil pressure?
EDIT: found on another page, can anyone confirm the red/yellow wire is oil pressure?
#28
Like Ghandi with a gun
Join Date: Mar 2003
Location: Rapid City, SD
Posts: 4,584
Likes: 0
Received 0 Likes
on
0 Posts
Ahh damn you guys are the bomb... Do I have to run that "condensor" (diode...capacitiator thingie that used to bolt to bellhousing (or was it the firewall?) parralellel or not? Do I absolute need it? Can I buy something at radioshack that would substitute?
#30
Former Moderator. RIP Icemark.
Thread Starter
Originally posted by Kenteth
Ahh damn you guys are the bomb... Do I have to run that "condensor" (diode...capacitiator thingie that used to bolt to bellhousing (or was it the firewall?) parralellel or not? Do I absolute need it? Can I buy something at radioshack that would substitute?
Ahh damn you guys are the bomb... Do I have to run that "condensor" (diode...capacitiator thingie that used to bolt to bellhousing (or was it the firewall?) parralellel or not? Do I absolute need it? Can I buy something at radioshack that would substitute?
It "T"s into the line, with one end going to ground.
Yes, you can replace it with a polar capcitor from radio shack.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM