Finally a little progress on the 20b install
Thread Starter
Senior Member
Joined: Nov 2003
Posts: 565
Likes: 1
From: Arizona
Finally a little progress on the 20b install
Finally the engine is in the car. After 6 months of working on it for an hour here and there. What did others do for a throttle cable bracket? I'm not sure what to make? I had a q45 tb on it before and the bracket was pretty simple.
-Destin
-Destin
Rest In Peace Dave
Joined: Feb 2004
Posts: 1,347
Likes: 1
From: Idaho
Originally Posted by sillbeer
Finally the engine is in the car. After 6 months of working on it for an hour here and there. What did others do for a throttle cable bracket? I'm not sure what to make? I had a q45 tb on it before and the bracket was pretty simple.
-Destin
-Destin
Last edited by bcool; Feb 20, 2006 at 05:32 PM.
multipersonality disorder
Joined: Feb 2002
Posts: 5,656
Likes: 0
From: so. cal
http://www.teamfc3s.org/forum/showth...5&pagenumber=3
this is a 2-rotor cosmo, but you can see how i did the bracket there...piece of cake.
this is a 2-rotor cosmo, but you can see how i did the bracket there...piece of cake.
multipersonality disorder
Joined: Feb 2002
Posts: 5,656
Likes: 0
From: so. cal
one thing to note though, pay attention to how long it is. that position hooks onto the cruise control thingy. you may have to play around with where you set your cable to make sure the throttle will still open up all the way. the cable will more than likely be run in without much slack.
i don't wanna read any threads a few months from now about how your 20b only did 190 whp because the throttle wouldn't open up all the way
i don't wanna read any threads a few months from now about how your 20b only did 190 whp because the throttle wouldn't open up all the way
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM