factory ecu without auto tranny
#1
Moderator
Thread Starter
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,832
Received 2,603 Likes
on
1,847 Posts
factory ecu without auto tranny
it does not work. you do not get fuel or spark. im pissed all that work to put it in the car, and nothing. you need some way to simulate the inhibitor switch, on all the other mazdas when the inhibitor switch is bad it wont start, same with the 20b ecu it seems.
will the e6k run the jc cosmo coils?
mike
will the e6k run the jc cosmo coils?
mike
Last edited by j9fd3s; 02-18-02 at 10:54 PM.
#2
Zilla Killer
Join Date: Mar 2001
Location: New Zealand
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
you can set up the factory ECU to run without the auto.
Lance Warren (www.3rotor.com) has factory ECU on his 20B HB Cosmo.
A guy here in NZ who goes by the name of Gizzmo set it up.
You apparently end up with about 10 or so wires left.
Lance Warren (www.3rotor.com) has factory ECU on his 20B HB Cosmo.
A guy here in NZ who goes by the name of Gizzmo set it up.
You apparently end up with about 10 or so wires left.
#3
Moderator
Thread Starter
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,832
Received 2,603 Likes
on
1,847 Posts
i probably should have gotten in touch with him, but its ok the s4 to 20b wiring ended up being kinda messy
mike
mike
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM