Any interest in Tec-IIs?
Thread Starter
Joined: Jun 2001
Posts: 1,294
Likes: 0
From: Apex, NC, USA
Any interest in Tec-IIs?
If all goes as planned, I'll be upgrading my twin Electromotive Tec-IIs to a Tec3r in a few weeks. I could sell the Tec-IIs on eBay or in the classified section of the forum, but it occurred to me that anyone doing a 20B conversion on a budget would benefit from being able to install a turnkey combination. If anyone is interested, please email me at rxx-7_owner@asam.cnc.net. Put "Tec-II" in the subject.
Thread Starter
Joined: Jun 2001
Posts: 1,294
Likes: 0
From: Apex, NC, USA
They're ready, now
I'm bringing this back, since the conversion has been done. I wanted to give people in this forum the first opportunity. There are two Electromotive Tec-II units set up to run a 20B, as well as device to change the output signal to the tach so that it will read correctly.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM
Cameron38
1st Gen General Discussion
2
Sep 19, 2015 11:45 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 10:46 PM