I just got an email from Tom from Payn technologies, inc. (www.payntechnologies.com) and he says that the aem only needs 5 drivers to run a 3 rotor
Quote
"What we would do is run the leading spark on the back rotors in wasted spark. This can be done since the rotor timing is the same".
Now can anyone understand that he said.
I am in desperate need to get a pms for my 20 B engine for drag race. I already got microtech but was desapointed because it is street use and not race or drag use, has a 8500 rpm setup limit. for example.

Bruno

 

I would stay way from that guy - he's a downright dumbfuck.

If the rotors were like the 13B, where they are offset by 180&#176, then he would be correct.&nbsp In reality, a stock 20B has it's 3 rotors offset by 120&#176, so running ANY of the leadings in wastespark is going to be firing them at the WRONG TIME - can you say DETONATION???



-Ted

 

I know that this will be difficult, but please try not to get too much into a flame war.

For further discussion see the duplicate post in the ECU forum:

https://www.rx7club.com/forum/showth...threadid=71767