20b Cas
09-04-05, 10:56 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2001
Location: trinidad, West indies
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
20b Cas
How do you go about setting the CAS sensor on the 20b after you installed a Haltech E11.I mean what position you insert the CAS when the pointer is on the yellow mark on the front pulley .
09-05-05, 04:02 PM
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,841
Received 2,604 Likes
on
1,847 Posts
i cheated with mine, i left it stock, got it close in the software and then just turned the cas manually to zero it
lazy...
lazy...
09-05-05, 10:54 PM
#3
Gone Darkside
iTrader: (14)
Join Date: Mar 2001
Location: Irmo, SC USA
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
When I restabbed my CAS to fix j9fd3s' screw up (just kidding), I did it pretty much the way it is shown on Hitman's site to get me close. Once I did that I just played with the numbers in the software (CTRL-I) to get it dialed in.
Hope this helps!
Reese
Hope this helps!
Reese
11-24-05, 10:08 PM
#4
Senior Member
Thread Starter
Join Date: Mar 2001
Location: trinidad, West indies
Posts: 265
Likes: 0
Received 0 Likes
on
0 Posts
here we go again
whats the stock set up to insert the cas on a 20b,find my car with the haltech E11 is hard starting like the timing is too advanced,
