Wiring pictures needed SA Early 79
12-09-07, 05:50 PM
#1
Full Member
Thread Starter
Join Date: May 2007
Location: OKLA CITY, OK
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Wiring pictures needed SA Early 79
We have an early 79 model bult 09/78 that had some rodent chew thru some wires. I have been patching wires that have been easy to figure out. There is one area at the driver side firewall where there are a few connections where I am just not sure where they go. Is there anyone out there willing to take some detailed pictures of this area so I can see where the wires go?
this is the main area at the far left side of the driver firewall where the main loom comes out
There is really only one section (not the main loom) but there are some break off wires that go to a few relays that I have questions about. The wires that go to the relays are intact, but would like to see as much info as possible. I have had to make new connections to the large gold box, but there is one blue solid wire that is on the male side that I have no clue where it came from. Would be willing to pay a few bucks via paypal for the trouble if that motivates. Please help. Thanks.
this is the main area at the far left side of the driver firewall where the main loom comes out
There is really only one section (not the main loom) but there are some break off wires that go to a few relays that I have questions about. The wires that go to the relays are intact, but would like to see as much info as possible. I have had to make new connections to the large gold box, but there is one blue solid wire that is on the male side that I have no clue where it came from. Would be willing to pay a few bucks via paypal for the trouble if that motivates. Please help. Thanks.
12-09-07, 06:17 PM
#2
7-less
Join Date: Dec 2005
Location: No. Virginia, USA
Posts: 2,053
Likes: 0
Received 0 Likes
on
0 Posts
12-09-07, 08:20 PM
#5
Full Member
Thread Starter
Join Date: May 2007
Location: OKLA CITY, OK
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
Link
Thanks for the link. Great piece of help there...will try to figure some things out from there....if I need pics, I will pursue that later if necessary. Thanks!
12-09-07, 11:51 PM
#7
Full Member
Thread Starter
Join Date: May 2007
Location: OKLA CITY, OK
Posts: 82
Likes: 0
Received 0 Likes
on
0 Posts
At this point, it looks like I have figured out most of it. All of the wiring I am dealing with is revolving around the regulator. After looking at the 79 diagram manual, it shows that white w/ red stripe and the solid yellow wire go to the regulator. Unless the regulator has some other pig tail harnesses somewhere, I am lost on where these go. It looks pretty obvious that they go somewhere other than the big 6 pin plug in. Help? Pics?
Thread
Thread Starter
Forum
Replies
Last Post