1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Whats the ticking noise?uurrrr

Thread Tools
 
Search this Thread
 
Old 05-14-04, 12:52 AM
  #1  
Senior Member

Thread Starter
 
rx_rotary's Avatar
 
Join Date: Aug 2001
Location: California
Posts: 315
Likes: 0
Received 0 Likes on 0 Posts
Whats the ticking noise?uurrrr

K.Started a couple days ago.Heard this tick tick tick when I would put in the clutch and slow down.But now its doing it all the time though the ticking is faster once i put in the clutch.It got worse since 2 days ago.I tried different things.reved the engine while not going thinking it was fuel pump but doesnt tick.But one thing I did notice is if i get a little air or go over a bump.when im in the air the noise stops then starts again right when i land(im not gettnig total air launching my car,just trying to explain it).Anyone have any idea? Also it will tick then when i slow down it slows down and stops when i stop.like this: tick.tick.tick..tick..tick...tick...tick....tick.. ..tick........tick.......tick..stopped.
I can only think of 2 things.brakes or my rear end. I stripped my interior.and when i feel behind my were the bins use to be thats where i can fill the most.right in the middle half way down the metal. I felt the top near spare tire and couldnt really feel the thumping.
Let me know what you guys think.THANKS!!!!
Old 05-14-04, 04:22 AM
  #2  
Senior Member

Thread Starter
 
rx_rotary's Avatar
 
Join Date: Aug 2001
Location: California
Posts: 315
Likes: 0
Received 0 Likes on 0 Posts
just to let you know.there's no vibration.so its not the U joints.
Old 05-14-04, 05:50 AM
  #3  
I read your email

 
inittab's Avatar
 
Join Date: Jan 2002
Location: NW New Jersey
Posts: 2,624
Likes: 0
Received 1 Like on 1 Post
Maybe there's a baseball card stuck in the spokes.

I dunno.... perhaps a shield or something is hitting the tires or driveshaft and when you "get air" the suspension drops enough for the noise to stop. Have you jacked up the car for inspection? That's what I'd do at this point.
Old 05-14-04, 05:55 AM
  #4  
Senior Member

 
Fuel524's Avatar
 
Join Date: Feb 2004
Location: FL
Posts: 312
Likes: 0
Received 0 Likes on 0 Posts
id suspect brakes first, or possibly bearings, then you can always disconnect driveshaft from tranny and jack up the car and spin the shaft by hand and see if it is rear end or not.
Old 05-14-04, 06:18 AM
  #5  
Senior Member

 
SERIES 1 XLR8's Avatar
 
Join Date: Nov 2002
Location: NEW ZEALAND.
Posts: 517
Likes: 0
Received 0 Likes on 0 Posts
my mum's mazda astina was ticking heavily on deceleration, although when i put the clutch in it almost stopped. It never ticked on acceleration though......Well i knew it was the gearbox right away. What she got it looked at, the guys in the shop said over $1000 to fix, so we just got a new used gearbox. Apparently the teeth on the gears were SEREWED, i hope it's not similar and is just , as said b4, a baseball card.

Doesn't seen 2 be the same thing, but just thought i'd tell my tick... tick... tick... story.

Last edited by SERIES 1 XLR8; 05-14-04 at 06:21 AM.
Old 05-14-04, 08:53 AM
  #6  
Smile Like a Donut

 
YapaKanichi's Avatar
 
Join Date: Feb 2004
Location: Don't you wish you knew....
Posts: 1,236
Likes: 0
Received 0 Likes on 0 Posts
try checking your belts your alt might have come loose. I found that out when I tested the new belts on mine, I had not tightened the alt enough and th belts loosened and it started to tick.
Old 05-14-04, 11:00 AM
  #7  
Rotor Power Rules

iTrader: (5)
 
Bruceman's Avatar
 
Join Date: Jul 2001
Location: Rochester Hills, MI
Posts: 525
Received 2 Likes on 1 Post
Sounds like the u joints
Old 05-14-04, 12:16 PM
  #8  
Senior Member

Thread Starter
 
rx_rotary's Avatar
 
Join Date: Aug 2001
Location: California
Posts: 315
Likes: 0
Received 0 Likes on 0 Posts
I jacked up my car yesterday and looked at everything and everything looked just fine.thats why im so frustrated. and the noise is coming from the rear so its no belt or anything.
Also I read about U joints and it says when they are bad you get vibration.I dont have any vibration.
Old 05-14-04, 01:01 PM
  #9  
Senior Member

Thread Starter
 
rx_rotary's Avatar
 
Join Date: Aug 2001
Location: California
Posts: 315
Likes: 0
Received 0 Likes on 0 Posts
I put my car on jackstands today in the rear and I started the car and let it go.Found out that the noise is coming from the middle front(front u-joint)...So I think it is the front u joint.thing is when i drove it other days I didnt feel vibration so didnt think it was the U-joint.But when I had my car on stands and ran it I felt the vibration!!!!
So what kind of play is there not suppose to be? Because when i shake the driveshaft left and right now play.But I can actually turn the driveshaft about 1/8th or so.

Thanks for all the help guys.Didnt have much time so I couldnt take off the shield.Is the shield even needed?I was thinking when I take it off just to toss it.
Old 05-14-04, 01:11 PM
  #10  
Senior Member

 
enigma32's Avatar
 
Join Date: Sep 2002
Location: Central New York
Posts: 686
Likes: 0
Received 0 Likes on 0 Posts
Bad U-Joints come in two styles....
1) Loose
2) Frozen.


Frozen U-Joints will cause nasty vibrations...

Loose U-Joints can cause clicking

You shouldn't have very much play at all...
If in doubt, pull the driveshaft and have it checked out.
Old 05-14-04, 08:40 PM
  #11  
Full Member

 
Join Date: Nov 2003
Location: Chico
Posts: 79
Likes: 0
Received 0 Likes on 0 Posts
If you pull the driveline off the car, look at the heat shield. Look at the area right above where the driveline slips into the transmission.
Old 05-14-04, 10:16 PM
  #12  
Senior Member

Thread Starter
 
rx_rotary's Avatar
 
Join Date: Aug 2001
Location: California
Posts: 315
Likes: 0
Received 0 Likes on 0 Posts
Tony Silva- what should I be looking for when I look at that heatshield?
Old 05-14-04, 10:41 PM
  #13  
DSM

 
RotaryRyan's Avatar
 
Join Date: Feb 2004
Location: Milton, FL
Posts: 2,070
Likes: 0
Received 1 Like on 1 Post
when i had a bad front ujoint, it made like a scratchy-clicking noise.
Old 05-23-04, 06:56 PM
  #14  
Full Member

 
Join Date: Nov 2003
Location: Chico
Posts: 79
Likes: 0
Received 0 Likes on 0 Posts
Scratches, or a clean area on the heatsheld.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
gxl90rx7
Haltech Forum
6
06-30-17 11:30 PM
Linda_Lovelace
General Rotary Tech Support
0
09-18-15 10:04 PM
zxrazorxz
3rd Generation Specific (1993-2002)
2
09-14-15 07:21 PM



Quick Reply: Whats the ticking noise?uurrrr



All times are GMT -5. The time now is 09:55 PM.