Which way does this thing go back together?
#1
Which way does this thing go back together?
I took the radiator shroud apart and had it sandblasted. After that I primed and repainted it and replaced all of the hardware. However, now I can't remember which way this little black rubber flap goes back on. This is on a 1985 GS. It snaps on to the bottom of the shroud with two little black plastic clips. I think it is supposed to seal around the wiring harness that passes underneath it.
Anyway, someone with a 1985, can you look at your car and tell me which way this thing is supposed to clip back on to the radiator shroud? Is either of the two pictures below correct? I want to make sure that I'm putting everything back together correctly.
Thanks,
Jamie
Anyway, someone with a 1985, can you look at your car and tell me which way this thing is supposed to clip back on to the radiator shroud? Is either of the two pictures below correct? I want to make sure that I'm putting everything back together correctly.
Thanks,
Jamie
#2
Lives on the Forum
Well, I keep looking back and forth between the two pictures, and I'll be darned if I can see any difference... What the heck are you talking about Jamie?
Okay, I see now. I believe my car decided at some point that that was an unneeded accessory. Sorry, can't tell you how it's supposed to mount.
.
Okay, I see now. I believe my car decided at some point that that was an unneeded accessory. Sorry, can't tell you how it's supposed to mount.
.
Thread
Thread Starter
Forum
Replies
Last Post
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM