1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Vacuum in gastank

Thread Tools
 
Search this Thread
 
Old Feb 7, 2002 | 05:21 PM
  #1  
Mschafe's Avatar
Thread Starter
Where did my 7 go?
Tenured Member 15 Years
 
Joined: Jan 2002
Posts: 357
Likes: 0
From: Burnsville, MN
Question Vacuum in gastank

I went to fill up today, and noticed a big woosh when I removed the gas cap. Does that mean anything? My engine has been starting to run strangly lately, and i've been trying to figure out whats wrong. Mabey it just needs a carb rebuild.


Matt
Reply
Old Feb 7, 2002 | 07:02 PM
  #2  
rotorhead's Avatar
Senior Member
Tenured Member: 20 Years
 
Joined: Apr 2001
Posts: 406
Likes: 0
From: indiana
mine usually goes 'whoosh' whenever it gets pretty low too.
Reply
Old Feb 7, 2002 | 09:09 PM
  #3  
hanman's Avatar
Rotary Freak
Tenured Member 20 Years
 
Joined: May 2001
Posts: 1,779
Likes: 0
From: Peoria, IL
Does it whoosh in or out? If it whooshes in you have a vacuum building up. This will cause your carb to starve and therefore the car run poorly to the point of stalling.
First try replacing the gas cap, then check the carb for proper venting into the charcoal canister.
hope this helps,
hanman
Reply
Old Feb 7, 2002 | 10:27 PM
  #4  
Pele's Avatar
Right near Malloy
Tenured Member: 25 Years
Liked
Loved
Community Favorite
iTrader: (28)
 
Joined: Dec 1999
Posts: 7,855
Likes: 517
From: Behind a workbench, repairing FC Electronics.
All the cars I've driven have had a vacuum when you open teh cap on empty.. I thought it was normal.
Reply
Old Feb 7, 2002 | 11:04 PM
  #5  
Mschafe's Avatar
Thread Starter
Where did my 7 go?
Tenured Member 15 Years
 
Joined: Jan 2002
Posts: 357
Likes: 0
From: Burnsville, MN
Just to note: The tank wasn't empty or low. I actually had a 1/2 a tank, and filled to full because I needed to drive a ways. I will check the canister thingy, and make sure all the venting lines are clear.


Matt
Reply
Old Feb 8, 2002 | 12:06 AM
  #6  
Sterling's Avatar
Nikki-Modder Rex-Rodder
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 2,890
Likes: 14
From: Trying to convince some clown not to put a Holley 600 on his 12a.
In my geriatric feeble mindedness, I can't remember who posted what... But someone just recently posted about troubles with his crank pressurizing -
Anyway, it was decided/discovered that his PCV valve was gunked up and not working. It could be a possibilty for your propblem too. Hanman has the place to start, though.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM




All times are GMT -5. The time now is 07:00 PM.