this is the last thing I have to do before start up. First of all, could somebody please tell me where these wires connect? I can't make sense out of the wiring diagram, and I can't see any connectors. Secondly, where do I mount the bracket that holds the +/- battery cables on their way to the starter?

 

The one hooks up to the oil pressure sensor and the other hooks up right next to the oil pressure sensor to the water sensor.

 

The battery cable bracket bolts to the rear plate/trans bolt just below the heater hose outlet.

The square connector goes to a temp sensor on the rear plate, below the oil pedestal.

Ther round connector is probably for the oil pressure sender that may car does not have, being only an '80 GS.

 

Okay, so I got the one hooked up to the oil pressure sender, but I already have the water temp sensor plugged in to another connector. Is there anything else the round one could be?

 

check the oil pan

 

okay, so I have that stuff taken care of, but I plugged the battery in and the cruise control started wigging out. wtf?

 

alright, last post was not clear. I have two more problems.

1) When I put the (-) battery cable on the battery, the hot start assist motor activates immediately. I am wondering if I maybe connected something wrong, but the wire goes directly from the motor into the wiring loom, around the front to the passenger side where there are 3 connectors without anything to go into. There's also one on the carb. Any ideas on this?

2) if I disconnect the hot start assist, and turn the key to the accessory position, the windshield wipers turn on. Where is the connection for the wiper motor?

 

The wiper connector is located onder the grill

 

Doble check the wire you connect nextto the oil pressure sensor

 

There are a few connectors in that area that are the same size and shape, and that can be misconnected; you really need to use the wiring diagram to check the color codes of the wires, to make sure you're hooking A to A.

Trying to do it by trial and error runs the risk of frying something.

 

okay, I think I have everything hooked up right this time. I do have an noob question though:

Where the hell does the ground battery cable hook up to the chassis?

 

It bolts to a threaded hole on the drivers side shock tower facing the engine. There should be an eyelet on the cable for it.

 

Goes right here:

 

thanks guys.