So my new engine is in. I hooked it all up. It wont start. Getting spark. Getting Fuel up to the fuel rail, not getting fuel into the enginei dont believe. My dad cranked it over and i put face near spark plug holes nad no gas smell . Tried adjust tps for the hell of it even though the engine isnt warm like its supposed to be i thoguht it may help . I hook up my lights, turn the screw. No lights come on. So i put on a multimeter and try again nothing. No matter how far i turn it i get no flow. So im assumingi need to replace my tps, or theres somethign electrical im forgetting that runs both my injectors and my tps. Any ideas?

 

Are the injectors connected?

Are the two black wires with the metal rings that are near the rats nest grounded?

Is the blue spade connector connected to the trailing coil?

Kent

 

my problem were the wires with the loops. grounded them and it started right up.

 

wat wires with the loops?

 

2 black wires, hmm where do they hook onto?

 

the are grounded into the rats nest. one 12mm bolt runs through them and a corner of the nest.

 

did you connect the battery? just kidding check your leads and your ground.

 

The black wires are grounds for the ecu. Without them, no injectors.

 

would that also explain why my tps isnt responding to adjusment?>

 

That could be. Try grounding those wires and find out.

Kent

 

i cant find the wires

 

You guys = teh best

That was my problem. Put it on started right up. Amazing. Sounds so badass

 

Sweet. Glad to see that you got it going.