It is time
#1
trainwreck
Thread Starter
It is time
Well, im finally ready to put together my new engine and install it. I have everyhtign that was unpainted painted so its allr eady, i think i have enough gaskets as well. Anyone got any tips on how to go about this. Should i put everythign on the block then put it in the car. Or should i put the short block into the car and bolt is all down, then put it all on? Any tips greatly apreciated
Last edited by BigJim; 02-17-04 at 08:31 PM.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM