TII Ignition Coil ?
Thread Starter
Joined: Jan 2005
Posts: 4,280
Likes: 5
From: Committe Chambers
TII Ignition Coil ?
I am in need of some technical help...
I have a TII swapped GSL-SE that was blow-thru with a Holley that I am switching back to FI and I have been installing a Microtech ECU for the last week. I am at the point where I need to wire in the TII coils BUT don't know how. I am using the CAS from the TII and got rid of my dizzy with ignitors. I am still using the SE harness so I need to know which wires go where to make these coils work. If anyone could shed some light it would be GREATLY appreciated.
Thanks
Joe
I have a TII swapped GSL-SE that was blow-thru with a Holley that I am switching back to FI and I have been installing a Microtech ECU for the last week. I am at the point where I need to wire in the TII coils BUT don't know how. I am using the CAS from the TII and got rid of my dizzy with ignitors. I am still using the SE harness so I need to know which wires go where to make these coils work. If anyone could shed some light it would be GREATLY appreciated.
Thanks
Joe
REW'd FB
Joined: Dec 2004
Posts: 2,685
Likes: 1
From: WA
Joe,
What model microtech do you have? One model allows you to use the stock coils the other requires bosh coils.
There is a lot of information on the microtech page on this.
You have a seperate harness for the Microtech, correct?
Dave
What model microtech do you have? One model allows you to use the stock coils the other requires bosh coils.
There is a lot of information on the microtech page on this.
You have a seperate harness for the Microtech, correct?
Dave
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
SakeBomb Garage
0
Sep 4, 2015 05:20 PM
SakeBomb Garage
Vendor Classifieds
0
Sep 4, 2015 05:19 PM