Those with Tokico Illuminas + GC Caster/camber plates
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2001
Location: Atlanta
Posts: 918
Likes: 0
Received 0 Likes
on
0 Posts
Those with Tokico Illuminas + GC Caster/camber plates
What did you have to do to make them fit? Just get the top of the shaft turned down a little bit? Anything else I need to get done?
#5
The General RE
Originally Posted by wackyracer
yup, got to bring it to machine shop to reduce the size (cant remember the size tho)...
#6
my fb is older than me
iTrader: (1)
Join Date: Aug 2004
Location: San Jose
Posts: 690
Likes: 0
Received 0 Likes
on
0 Posts
well if u want to go even wilder, u can run 85-86 mr2 rear shocks. it will fit in out spindles and is the correct diameter for gc camber plate. its a 5/8's i believe.
i came across this on the mazdatrix website. their "race" illumina for fb's are 85-86 mr2 rear shock and they say it can bolt up to their 5/8in diameter camber plate. i added 1+1 and that turned out to be (MR)2. i have never tried it myself; i wish i have but i have no money at the moment.
http://mazdatrix.com/r-susp-1.htm
if u dont believe me u can figure it out yourself too.
i came across this on the mazdatrix website. their "race" illumina for fb's are 85-86 mr2 rear shock and they say it can bolt up to their 5/8in diameter camber plate. i added 1+1 and that turned out to be (MR)2. i have never tried it myself; i wish i have but i have no money at the moment.
http://mazdatrix.com/r-susp-1.htm
if u dont believe me u can figure it out yourself too.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM