A/T to Manual Transmission swap help needed
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Marlborough,Ma
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
A/T to Manual Transmission swap help needed
I looked trust me I did, and I have no doubt it's here, somewhere
I am looking for information on converting a automatic, to a standard.........If some one can put up a link it would most appreciated....
I am looking for information on converting a automatic, to a standard.........If some one can put up a link it would most appreciated....
#2
Out In the Barn
iTrader: (9)
https://www.rx7club.com/showthread.p...p+in+%2785+gsl
Make sure you get the correct flywheel:
http://www.mazdatrix.com/faq/flywheel.htm
You will also need the following (this is not a complete list)
1. Pedals from correct year RX-7 (79-83) (84-85)
2. Correct flywheel for the year of the engine.
3. Manual model starter
3. Correct driveshaft for the model years.
4. Correct year computer - depending on year this may not be required
5. Fabricated transmission mount
One word of advise. When removing the pedals, there is one long bolt at the top for the 84-85 model years. Regardless of year, do not remove the steering column bolts. It's not needed.
#3
Lives on the Forum
iTrader: (13)
As far as driveshafts go, depending on the year of your 7 you might be able to use your existing one.
Computer or Emission ECU is not a factor.
Do not have to fabricate a transmission mount. Just get the M/T crossmember and use the M/T trans mount.
Very important part to remember. Make sure you install a pilot bearing and seal in your engine before installing the trans. :-)
Computer or Emission ECU is not a factor.
Do not have to fabricate a transmission mount. Just get the M/T crossmember and use the M/T trans mount.
Very important part to remember. Make sure you install a pilot bearing and seal in your engine before installing the trans. :-)
Thread
Thread Starter
Forum
Replies
Last Post