What would you recommend for fuel for a TII setup.

Right now it is a totally stock motor with stock turbo, but I hope to have about 350-400 when I am done.
this is in a 82 s.

I need to know what I need to fuel this kind of power.

 

go here... http://www.maxcooper.com/rx7/how-to/...tem/calcs.html

before my car was so rudly and abruptly jacked. https://www.rx7club.com/forum/showth...ell+fuel+setup
it was a pretty burly setup and was going to be used for track racing.

 

well my friend had a 87 t2... gsl-se injectors in the mains a s-afc a to4,streetoprt, and fmic, some other small **** to..... almost 400 on the ground... but ran out of fuel... so he got 1200cc injectors and a huge pump....but sold it b 4 the stuff was installed

 

where can I find pumps for this, that site said I needed a 75 psi pump.

 

what about the Rotary Performance upgraded pump? is this a intank or could I run it remote?

 

its intank but ive heard from a local friend that had it on a single turbo fd it ran out of steam at high load. the bosch pump i got was from rpm performance. its in australia but they have plenty of good stuff down there..

 

SO do you guy's have a second gen engine in your first gen? IF so what kind of modifications besides the engine did you have to make and was it very difficult? I am thinking about restoring an engine out of a second gen that i found at the junkyard for $125 and putting it in my first gen so i can get more power.. How much power can i get out of a turboed second gen 13b??


Thanka for all the help

JOSHUA

 

13bt power

full bridge large single turbo 600+

streetport with large single 400+

stock turbos 265-280

 

a streetported 87t2 with hybride t04 300+

 

if I run that RP or boshe pump remote, can I use the stock pickup, it seams kind of small???

how hard would it be to set up a pickup at the back of the tank.