Steering problem
#1
Full Member
Thread Starter
Join Date: May 2005
Location: austin TX
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Steering problem
81 gsl
Ok so i have 2 problems with my steering. One is the gap, or lag. Not sure what to call it, basically theres a 1 inch space when turning the wheel before response. I checkd and made sure the bolt is on tight.
The other problem which is a bigger one for me, is that the steering doesnt starighten out when you complete a turn. So if Im on the road at 40 MPH and Im turning slightly to the right, i can let go and it will stay goig to the right, same with turning left. I have to straighten it out myself. (no Im not lazy , I just know something is wrong and would like it fixed )
Ive replaced the idler arm, pitman arm, and I have two new front tires, balanced and got an alignment.
?? any ideas or things to look for?
Ok so i have 2 problems with my steering. One is the gap, or lag. Not sure what to call it, basically theres a 1 inch space when turning the wheel before response. I checkd and made sure the bolt is on tight.
The other problem which is a bigger one for me, is that the steering doesnt starighten out when you complete a turn. So if Im on the road at 40 MPH and Im turning slightly to the right, i can let go and it will stay goig to the right, same with turning left. I have to straighten it out myself. (no Im not lazy , I just know something is wrong and would like it fixed )
Ive replaced the idler arm, pitman arm, and I have two new front tires, balanced and got an alignment.
?? any ideas or things to look for?
Last edited by Mikeee; 06-20-05 at 01:50 AM.
#2
Bubble Gum's Good
iTrader: (1)
Join Date: May 2005
Location: Norfolk, VA
Posts: 625
Likes: 0
Received 0 Likes
on
0 Posts
I got the same prob. I just bought a new used column and gear, and i'm just gonna rip it all out and put all new stuff in. Sucks when you got a smoke in one hand and a drink in hte other. Rx made me spill my beer.
#3
Rotary Freak
Join Date: May 2001
Location: Peoria, IL
Posts: 1,779
Likes: 0
Received 0 Likes
on
0 Posts
First check the idler arm. They all go bad in the first gen. Too close to the exhaust. Then I would completely go through the front end. Tie rod ends, ball joints, everything. Then finally, if you still have the problem you need to tighten the nut on top of the steering box.
http://www.mazspeed.com/steeringgear.htm
http://www.mazspeed.com/steeringgear.htm
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM