Speedo cable
Thread Starter
Senior Member
Joined: Mar 2001
Posts: 357
Likes: 0
From: somewhere
Speedo cable
Hey, I posted a response to this thread https://www.rx7club.com/forum/showth...&postid=820912 but it doesn't seem too active, so, I'll go over it again 
THe speedocable on my '85 GSL-SE is dead methinks, do I just have to rip it out and get a new one from mazda/a junkyard or is there something more common that happens, like does it just disconnect behind the gauge or something?
THe speedocable on my '85 GSL-SE is dead methinks, do I just have to rip it out and get a new one from mazda/a junkyard or is there something more common that happens, like does it just disconnect behind the gauge or something?
Joined: Oct 2001
Posts: 6,444
Likes: 0
From: Fort Branch, Indiana
Ive had one snap in the middle before in my 80. I picked one up at the dealer... 
I was invesigating the problem remove the cable and the end tried to come ALL the way out. So after about 2 foot of pulling it was snapped in 1/2
I was invesigating the problem remove the cable and the end tried to come ALL the way out. So after about 2 foot of pulling it was snapped in 1/2
Last edited by MIKE-P-28; Jul 6, 2002 at 06:55 PM.
Full Member
Joined: Jun 2002
Posts: 142
Likes: 0
From: Ottawa, Canada
I'll borrow from this thread! I've got an 84 GSL-SE that has a speedo problem, but not a usual one...
At about 7 mph, it clocks 220KM/h, but goes back to 0 as the cars slows to 0.
On the plus side, it's accurate when I'm not moving, or if I'm doing 220Km/h...
Anyone have any thoughts?
At about 7 mph, it clocks 220KM/h, but goes back to 0 as the cars slows to 0.
On the plus side, it's accurate when I'm not moving, or if I'm doing 220Km/h...
Anyone have any thoughts?
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
Sep 30, 2015 08:13 PM
Thor 18
3rd Generation Specific (1993-2002)
5
Sep 28, 2015 07:35 PM
