somebody using a holley 650 as a blow thru here?
Thread Starter
Joined: Nov 2001
Posts: 2,239
Likes: 1
From: Watertown, NY
somebody using a holley 650 as a blow thru here?
does anybody in the 1gen furum use a holley 650 as blow thru setup? how does it perform? does is hard to start? im asking because a friend of mine wanna know and hes planning to put a 91 turbo II engine with holley. thanks and merry christmas
Me!
So far it's AWESOME.
I am almost done tuning it, and will likely finish the secondaries today.
When I start it, it idles fine, but I can't give it any gas for about two minutes, until it's a little warmed up. I think that's all carbs though, as even nikki carbs had chokes for this.
I am not running any chokes.
Other than that, its perfect. Just like my stock SE, with a perfect idle at 900 RPM.
The power is amazing, and I am only referring to 10PSI. (no creep either). At 15 PSI it's incredible, and at 17 PSI it's downright scary.
So far it's AWESOME.
I am almost done tuning it, and will likely finish the secondaries today.
When I start it, it idles fine, but I can't give it any gas for about two minutes, until it's a little warmed up. I think that's all carbs though, as even nikki carbs had chokes for this.
I am not running any chokes.
Other than that, its perfect. Just like my stock SE, with a perfect idle at 900 RPM.
The power is amazing, and I am only referring to 10PSI. (no creep either). At 15 PSI it's incredible, and at 17 PSI it's downright scary.
