Short Shifters-Proof of Life
#1
Still Dreams of 3rd Gen
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: Owensboro, Ky
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
Short Shifters-Proof of Life
They're not all ready yet, but this is just so you guys know I go got 'em.
Between all the slackin off, I've been a little busy.
Sorry the deadline's been pushed back 2300 times.
I have a shifter installed in my 82 with the new cnc'd spacer and I'm pretty pleased. No rattling yet but this is only on one car. I'm going to try to make an install tutorial before the end of the week so you guys know what you're getting into.
Between all the slackin off, I've been a little busy.
Sorry the deadline's been pushed back 2300 times.
I have a shifter installed in my 82 with the new cnc'd spacer and I'm pretty pleased. No rattling yet but this is only on one car. I'm going to try to make an install tutorial before the end of the week so you guys know what you're getting into.
#5
Still Dreams of 3rd Gen
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: Owensboro, Ky
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
$75.00 shipped on this batch. Most of them are accounted for (you know who you are), some of you will get pm's first, and after that it's first pay.
I'm going to reinvest most if not all profits into another cnc order and that will take a month or month and a half.
I need cores, i don't really want to mess with one or two, I'll make someone a deal if you have several to unload. I'm going to look into making the rods from scratch, but it's beyond my tooling capabilities right now and I'm afraid the cnc will raise cost too high.
James Hull, we still got a deal? PM me.
I'm going to reinvest most if not all profits into another cnc order and that will take a month or month and a half.
I need cores, i don't really want to mess with one or two, I'll make someone a deal if you have several to unload. I'm going to look into making the rods from scratch, but it's beyond my tooling capabilities right now and I'm afraid the cnc will raise cost too high.
James Hull, we still got a deal? PM me.
Trending Topics
#9
Banned. I got OWNED!!!
iTrader: (3)
Yea, call Billy
I sent him (jorx81) a PM a while back. It may be he feels I would "steal" the design. Non-valid concern but understandable.
A few notes:
1) I can do the engineering myself, no need to steal his.
2) I work for some big name companies under non-disclosure and non-compete contract. I would extend the same to him.
I sent him (jorx81) a PM a while back. It may be he feels I would "steal" the design. Non-valid concern but understandable.
A few notes:
1) I can do the engineering myself, no need to steal his.
2) I work for some big name companies under non-disclosure and non-compete contract. I would extend the same to him.
Last edited by Re-Speed.com; 04-28-05 at 11:38 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
23Racer
Race Car Tech
1
09-21-15 10:48 AM