SE susp. swap????
04-06-04, 09:32 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2003
Location: East NC
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
SE susp. swap????
I want to swap over to GSL-SE susp. in my GSL. Couple of questins. What all do I actually need to get off of the se front end to put on my GSL. Do I just need spindles, rotors, and brakes? Also the Se rear end may not have the pumpkin in it. Can I just put my std. 3.90 LSD GSL pumpkin in it? Any replys would be appreciated.
04-09-04, 09:53 PM
#3
Where did my 7 go?
Join Date: Jan 2002
Location: Burnsville, MN
Posts: 357
Likes: 0
Received 0 Likes
on
0 Posts
Well.. I'm helping Cody (on the forum) do a GSL-SE suspension swap. Basically you take EVERYTHING off the front (disconnect everything down below, and unbolt the whole thing from the strut tower on both sides). On the rear, we dropped the whole thing with diff, axels, etc... I'm not sure however if your existing diff will work with the GSL-SE axels, etc...
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
gtcd
1st Generation Specific (1979-1985)
3
09-17-15 01:15 PM
gabescanlon
3rd Generation Specific (1993-2002)
2
09-15-15 06:57 AM
jakeishness
2nd Generation Specific (1986-1992)
11
09-11-15 11:33 AM