1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Se help needed. Idles fine till I run it, then it hangs at 2k

Thread Tools
 
Search this Thread
 
Old Aug 16, 2012 | 06:17 PM
  #1  
jkevin50's Avatar
Thread Starter
Senior Member
Tenured Member 10 Years
iTrader: (12)
 
Joined: Oct 2008
Posts: 289
Likes: 2
From: Florida
Se help needed. Idles fine till I run it, then it hangs at 2k

Idle is dead on at 800 wo the bacv. Runs great until I go for a trip and the idle gets hung up at 2k, I blip the throttle it goes back down. Check the tps and adjusted, on the tps it reads 6.26k ohms at WOT, in the manual it states 5k. Wonder if it is bad? The car was a mess when i got it and every screw was messed with. So I put it back to what I consider good settings did the standard idle adjustment, now the car is fine until I go then every time I shift it "hangs at 2k" blip the throttle down to 800. Any ideas? I just cleaned the throttle body again. Thank in advance!

Kevin

Here is the info on the car,
71k miles, great compression just did a new fuel pump, filter, injectors, button, cap, lower and upper manifold gaskets, grommets for injectors, air filter, plugs, wires adjusted timing.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
Haltech Forum
11
Mar 11, 2019 05:34 PM
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
Aug 26, 2015 09:52 PM
ncds_fc
New Member RX-7 Technical
1
Aug 15, 2015 10:06 AM




All times are GMT -5. The time now is 11:19 PM.