SA Oil pan sensors
#1
Senior Member
Thread Starter
SA Oil pan sensors
There are two holes on the left side of the oil pan and 2 sensors that go in them. One has two wires an is about 3 inches long. The other is short and has a single wire. Which goes in the front upper hole and which goes in the lower rear hole,
Thanks for the help, Herb
Thanks for the help, Herb
#2
Out In the Barn
iTrader: (9)
One is oil level sensor and the other is the sub zero sensor.
http://www.foxed.ca/rx7manual/manual...ingDiagram.pdf
Sub-Zero is A-07 (page A) and is the most forward sensor
Oil level sensor is C-06
The Sub-Zero system never worked right. I'd remove the sub-zero tank. I think there was a TSB that said to keep the sub-zero pump unplugged
http://www.foxed.ca/rx7manual/manual...ingDiagram.pdf
Sub-Zero is A-07 (page A) and is the most forward sensor
Oil level sensor is C-06
The Sub-Zero system never worked right. I'd remove the sub-zero tank. I think there was a TSB that said to keep the sub-zero pump unplugged
Last edited by KansasCityREPU; 05-21-17 at 04:32 PM.