ReSpeed Crossmember and Rack Kit
11-22-07, 01:55 AM
#101
Hey Billy,
Sorry to revive an old thread but I have another question if its not too much trouble. I did not notice this till today, when my buddy came over and pointed it out, but in your pictures on your website, and here, you should the crossmember with 6 holes drilled through it for adjustability options, same for the triangle parts that go on the frame rail for the arms. But in my kit and looking at the pic from Joe's thread, there are only 3 holes as opposed to the 6. Any reason for the downgrade in the amount of adjustability?
Sorry to revive an old thread but I have another question if its not too much trouble. I did not notice this till today, when my buddy came over and pointed it out, but in your pictures on your website, and here, you should the crossmember with 6 holes drilled through it for adjustability options, same for the triangle parts that go on the frame rail for the arms. But in my kit and looking at the pic from Joe's thread, there are only 3 holes as opposed to the 6. Any reason for the downgrade in the amount of adjustability?
11-22-07, 08:22 AM
#102
Hey Billy,
Sorry to revive an old thread but I have another question if its not too much trouble. I did not notice this till today, when my buddy came over and pointed it out, but in your pictures on your website, and here, you should the crossmember with 6 holes drilled through it for adjustability options, same for the triangle parts that go on the frame rail for the arms. But in my kit and looking at the pic from Joe's thread, there are only 3 holes as opposed to the 6. Any reason for the downgrade in the amount of adjustability?
Sorry to revive an old thread but I have another question if its not too much trouble. I did not notice this till today, when my buddy came over and pointed it out, but in your pictures on your website, and here, you should the crossmember with 6 holes drilled through it for adjustability options, same for the triangle parts that go on the frame rail for the arms. But in my kit and looking at the pic from Joe's thread, there are only 3 holes as opposed to the 6. Any reason for the downgrade in the amount of adjustability?
Never to much trouble. The extra hole were removed for strength and longevity. All production units are this way.
-billy
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
13b, 85, adjustment, billys, conversion, crossmember, crossmemmber, fb, motor, mounts, rack, respeed, rp, rx7, single, turbo
