Replacing Ash Tray with Gauges
Replacing Ash Tray with Gauges
Has anyone used the ash tray space for gauges? I think I'm gonna get a wide band and I may put it there instead of on the pillar. I have used up all of the other spaces with gauges already. If anyone has done this, can you post some pics? Maybe we could get akiratdk to make something. Oh yeah, I will be doing this on the 84-85 style.
i havent for that but I have used it for switchs. But I left the ashtray intact and then made a plate for them to mount to, then ran the wires in through some holes I drilled in the bottem, worked good and concealed the switchs. It shouldnt be hard though, the whole ash tray assembly can be taken out by removing 4 screws if I remember correctly. Then you just fab up your sheet metal or what have you and your good to go.
sweet. I was thinking of trying to make a plate or even use the front of the ashtray ( I have a few spares). Make the hole and use some type of plastic pipe to put behind the gauge to fill in the uneven space from the curve of the ashtray.
Here you go....this is what I did:
https://www.rx7club.com/showthread.p...light=ash+tray
I'm surprised I don't have a picture of it installed in the car. I can get one if you want to see it.
Rich
https://www.rx7club.com/showthread.p...light=ash+tray
I'm surprised I don't have a picture of it installed in the car. I can get one if you want to see it.
Rich
Wow, thanks man, that gives me some ideas. I would like to see a pic of your stereo surround with gauges installed if possible. Very clean job! Of yeah, does that plate curve like the ash tray or is it straight?
Rich
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
RCCAZ 1
1st Generation Specific (1979-1985)
5
Aug 11, 2015 07:05 PM




