Recommended or not?
Thread Starter
Banned. I got OWNED!!!
iTrader: (2)
Joined: Oct 2004
Posts: 6,122
Likes: 1
From: London, Ontario
Recommended or not?
http://www.mazspeed.com/atf.htm
I was reading this about reviving engines ... would this be a good idea for all our cars to clean them out even though they're running alright? I'm about to install my gas tank on saturday and the car hasen't started in quite a few months.
I was reading this about reviving engines ... would this be a good idea for all our cars to clean them out even though they're running alright? I'm about to install my gas tank on saturday and the car hasen't started in quite a few months.
My wife bought me 2 RX-7s
Joined: Aug 2001
Posts: 2,328
Likes: 3
From: Saskatoon, Saskatchewan, Canada
Check out the FAQ at the top of the page.
The 'ATF Trick' has its place, but I don't see any reason to use it on a running engine unless you're certain it has low compression. Also, if you're installing a new gas tank, I would suppose that the old one was rusty. That will definately gum up your carbuator and your fuel filter. You should replace the filter and perhaps rebuild the carb.
The 'ATF Trick' has its place, but I don't see any reason to use it on a running engine unless you're certain it has low compression. Also, if you're installing a new gas tank, I would suppose that the old one was rusty. That will definately gum up your carbuator and your fuel filter. You should replace the filter and perhaps rebuild the carb.
Thread Starter
Banned. I got OWNED!!!
iTrader: (2)
Joined: Oct 2004
Posts: 6,122
Likes: 1
From: London, Ontario
i don't know how the condition of the gas tank was because it was off from the junk yard that i got the car at, so i would assume that it was a good one and someone took it ... i have changed the fuel filter and still thinking about the carb rebuild kit from V.B.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM
rotor_veux
2nd Generation Specific (1986-1992)
3
Sep 28, 2015 09:25 PM
Sammy Built
Haltech Forum
8
Sep 28, 2015 03:18 PM



