my rear defrost wires are not attached to the windows how can i do a quick fix on this? would it be possible if i were just to solder it back on to the window

 

Solder them back to the window. Click this link Defroster and scroll down to the defroster section.

 

You can solder it back to the glass if theres anything to solder too, cross your fingers and hope there is , other wise theres really nothing you can do

 

As long as there are the 2 strips where the wires went.
on the window your ok to solder. if there are no connectors left on the window, you can use just wire connectors, the 2 piece kind, one end solder to the window, the other, to the coil wires. I would say solder to the window first. use at least a 100 watt soldering iron.(because the glass acts like a big heat sink) all pieces,, file,, to clean metal, it'll stick better that way.
and use a 50/50 or 60/40 solder and water base flux.

 

on the coil wires theres a little like metal plate attached like a little square? would i still be possible to solder it back to the window ??

 

Yes

 

That my friend would depend on how well you can solder. Sure you could,trying to solder in that area is a pain in the *** though (with the coil wire attached) use some hymo's to hold the piece. ( gets hot,real fast ) if you use your fingers, file all pieces, ,,, same gig.