Rear Brake Rotors
#1
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jan 2003
Location: Bryan, TX
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
Rear Brake Rotors
I got a set of rear rotors for my GSL from oreilly auto parts. They are wagner rotors. Neither of them fit, just a few mm off on all the holes. Anybody have this experience before?
#2
Too old to act my age
Join Date: Feb 2005
Location: Tulsa, Ok.
Posts: 3,164
Likes: 0
Received 0 Likes
on
0 Posts
Sounds like they sold you rotors for a GSL-SE. Those are vented, and use a larger bolt pattern for the wheels. GSL rotors should be a solid disk. Part number BD60698, if the website is giving me the right info....
Last edited by Rogue_Wulff; 06-28-05 at 08:08 PM.
#3
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jan 2003
Location: Bryan, TX
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
Ya, Its part number BD60698. Non-vented. It is about 2 mm off from each hole. The screw holes are too far out, and 3 of the lugs are off 3mm. Both are off the same amount.
#4
Too old to act my age
Join Date: Feb 2005
Location: Tulsa, Ok.
Posts: 3,164
Likes: 0
Received 0 Likes
on
0 Posts
Lug holes too far apart? or too close together? The S/GS/GSL and GSL-SE bolt pattern is only 4.3MM difference total. Perhaps someone replaced the rearend with an SE unit?
#5
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jan 2003
Location: Bryan, TX
Posts: 766
Likes: 0
Received 0 Likes
on
0 Posts
Ya, I mesured everything out and it is the stock rear end. By the mesurements that I can do on the new vs old rotor, I think they stock the -SE rear caliper for both rear ends.
Not very pleased with them now. Any place I can get a set of cheap rear rotors?
Not very pleased with them now. Any place I can get a set of cheap rear rotors?
Thread
Thread Starter
Forum
Replies
Last Post