rb presilencer, need a measurement,help!
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2004
Location: Campbell, CA
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
rb presilencer, need a measurement,help!
Does anyone have a rb presilencer sitting around? I'd like to know the lenght end to end (not including studs) and whether it looks like it is straight. I'm trying to get a cat fabbed up so that I can run the RB header with a cat that i can swap in and out.
Thanks,
Alvin
Thanks,
Alvin
#3
Senior Member
Join Date: Nov 2004
Location: Birmingham AL
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
If I remember correctly it is 20". You will actually mount the flanges for the cat onto pieces of pipe and not actully on the cat. These will then slide into the inlet/outlet sections of the cat giving you the ability to easily adjust your cat length by 2". Once installed you can clamp the connections.
#4
Rotary Enthusiast
Thread Starter
Join Date: Dec 2004
Location: Campbell, CA
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
cool, thanx, I was actually going to have the pieces welded (i'm not a big fan of exhaust clamps) I just need to have a cat in there because of cali smog... I'm just going to pick up the end flanges from rb and have the exhaust shop weld it all up.
Thanks again!
Alvin
Thanks again!
Alvin
Thread
Thread Starter
Forum
Replies
Last Post
jeremyferguson4444
1st Generation Specific (1979-1985)
8
09-19-15 01:27 PM