Radiator and Cooling System Capacity
#1
Senior Member
Thread Starter
Join Date: May 2007
Location: Loveland CO
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
Radiator and Cooling System Capacity
I'm in need of changing my coolant in my 79 before the cold hits hard tomorrow.
I don't know how much coolant the cooling system will hold. can anyone help me out?
I read through the cooling system section in the FSM for the 1980 RX-7 and I can't find an ammount All I'm seeing is 50/50 coolant/demineralized water...
I don't know how much coolant the cooling system will hold. can anyone help me out?
I read through the cooling system section in the FSM for the 1980 RX-7 and I can't find an ammount All I'm seeing is 50/50 coolant/demineralized water...
#4
RX HVN
iTrader: (2)
FSM sez 10 US quarts INCLUDING HEATER - not likely to get it all out, but best way to get most:
-disconnect bottom rad hose from rad
-make sure you remove the 14mm bolt on center housing to drain block - below dip stick assy and just above oil pan edge
Once you have filled as much as it will take, make sure you run it to warm-up temp then re-check level - don't forget to 1/2 fill overflow tank
-50/50 should be plenty
Stu Aull
80GS
Alaska
-disconnect bottom rad hose from rad
-make sure you remove the 14mm bolt on center housing to drain block - below dip stick assy and just above oil pan edge
Once you have filled as much as it will take, make sure you run it to warm-up temp then re-check level - don't forget to 1/2 fill overflow tank
-50/50 should be plenty
Stu Aull
80GS
Alaska
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FD RX-7
8
10-09-15 10:05 PM
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM