Problem over heating 12A!
#1
Full Member
Thread Starter
Join Date: May 2002
Location: Texas
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
Problem over heating 12A!
I just pulled out the emissions and air pump , its running on 1 pulley and im hoping that the pulley is skipping , it over heats when still and am in process of buying double pulley the heating level goes over half then back to normal when i drive it!
#3
thats something I need to look into, I've replaced the radiator, fan clutch, water pump and seals, thermostat, skid guard, and am now running about 80% water. It still overheats on hot days.
#4
Rotary Freak
its actually probably not because your belt is slipping,
check fluid level and flush,
check thermostat
check pump it could be bad
does pump make any noise at all?
is there any brown residue as if water where leaking from front of pump?
check that stuff first before you assume the belt
check fluid level and flush,
check thermostat
check pump it could be bad
does pump make any noise at all?
is there any brown residue as if water where leaking from front of pump?
check that stuff first before you assume the belt
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM