Photos of OMP to throttle linkage
#1
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Orangeville, Ontario
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Photos of OMP to throttle linkage
I accidentally bent my omp rod that goes to the throttle assembly while cleaning it, does anyone have a picture of how it is supposed to be bent?
Edit: Also, is the part the rod connects to on the omp lever supposed to rotate or is it fixed?
Edit: Also, is the part the rod connects to on the omp lever supposed to rotate or is it fixed?
#2
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Orangeville, Ontario
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Ok, I think I got a good enough picture from the parts manual to figure out how the rod was bent. But I still haven't figured out if the part the rod goes through that connects it to the oil metering pump is supposed to rotate or if its fixed on the lever on the pump
#6
Junior Member
Thread Starter
Join Date: Jun 2006
Location: Orangeville, Ontario
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
12A, I always forget that there was a13B in the FB...
I freed up the piece and now the whole assembly seems to work much smoother and doesn't stick.
I freed up the piece and now the whole assembly seems to work much smoother and doesn't stick.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM