OK..... I got the air horn off my carb, cause it wont run right.... it will start, and then stall..... then I could pump the gas.... and it would start again...... so I was told that I need to clean the jet,bleeds, ect...ect...ect.... well... I am doin this now..... I am wondering.... what can I yank off my carb??? I mean.... there is a bunch of **** on it..... I dont care about emissions, or a choke.... So... what can I yank?

Oh yeah... what should I clean the carb with???


THANX.... LATERZ... Andrew

 

When I had the Nikki I ripped basically everything off the carb and it worked perfectly all the time.

The only things left were the throttle linkage, choke linkage and OMP linkage.

I left the choke linkage on so I could keep the revs up when the engine's cold but the actual choke plate and shaft were removed.

 

THANX SOOO MUCH... I guess I will go ahead and yank alot of **** off.....THANX


Well.... all my **** was ALLL gummied up... and FILTHY with corrosion... so I cleaned most of it.... poored gas down where the float are.... turned it over... she sarted right up.... and purred until the gas was gone... so I am now cleaning my ****.... AND THEN GO HAVE SOME REAAL FUN THANX EVERYONE