No air from head level vents when set to bi-level.
09-07-13, 10:31 AM
#1
Full Member
Thread Starter
Join Date: Sep 2011
Location: Camp Pendleton, CA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
No air from head level vents when set to bi-level.
I had to replace my blower motor resistor. I now got everything hooked back up the right way, I have no seals so I'm not losing air to leak and the cable that actuates the flap does its job when switching between recycle and bi-level. On recycle I get air coming through the face level vents but on bi-level where I can get fresh cold air it only comes out the bottom vents by my feet. I am at a loss as to what could be the cause, has anyone seen this before?
10-19-13, 12:30 PM
#2
Junior Member
Join Date: Aug 2004
Location: Ontario, Canada
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Sorry I can't help with your problem. I don't think the blower motor resistor would have anything to do with this. Did you fix the problem?
I do need to replace my resistor but am having trouble sourcing it. Where did you get yours. I am working on a '88 vert. Have attached picture of the resistor. I think it is an update from the open coil style. The older one is easier to source.
I do need to replace my resistor but am having trouble sourcing it. Where did you get yours. I am working on a '88 vert. Have attached picture of the resistor. I think it is an update from the open coil style. The older one is easier to source.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM