well to start i bought an 1985 rx7 12a
$450 near perfect interior a little bit of dry rot on the steering wheel thats all
pretty got body except passenger fender and bumper
and a clean engine
its not bad for an 85

but i have here a 13b-rew engine trans ecu harness fuel pump well to sum it up a 1988 rx7 gtu with a 13b-rew that runs really good but its getting a 13bTT swap so i want the current engine in my 1st gen
how hard would this be what all do i need any cool step by step instructions around here or would it bolt right in ??

well thanks in advance ill put some pics up soon

 

very hard.

Has been done but not overly many times, do a search, welcome to the forum.

 

i looked but no good
what all will i need any one have a list
or am i better off just keeping this 12a?

 

What are your goals with the car? That will make all the diff.

 

should be fun

 

its my dd / drift car i got my diff welded soon to order my suspension and get some welding done to my body i just dont this little 12a can do what i need to do
it has 224,xxx miles on it and still runs pretty strong

 

I'm confused.

Do you want the 13BREW in or the GTU motor ?

 

how hard did you look? 1st page in archive has both t2 swap and 20B swap

The Chronicles of a Turbo II Swap
and
(ENGINE) 20B First Gen RX-7

quick search of "rew" in the first gen section yields a few good results such as 13B-REW into first gen and 13B REW redo.

https://www.rx7club.com/search.php?searchid=5022518

 

ill look harder for some stuff
and the gtu has a 13b-rew i just swapped in last year