need info
need info
10-13-06, 02:40 PM
#2
unregistered rex offender
Join Date: Oct 2003
Location: Spokane, Washington
Posts: 1,644
Likes: 0
Received 0 Likes
on
0 Posts
I believe you can run a 12a tranny. I know you can run a 13b tranny with a 12a, so I would assume it's the same bolt up.
If you're asking about rotor housings, I think it's a 10 or 11 mm difference in thickness.
If you're asking about rotor housings, I think it's a 10 or 11 mm difference in thickness.
10-14-06, 12:07 AM
#3
FB+FC=F-ME
Bell housing pattern is the same for all rotaries except the very early ones.
You can run any RX-7 tranny on any RX-7 engine provided you mix and match the correct flywheel/counterweight,clutch and starter for the application you are putting together.There are minor differences in the shifter location and rear mount,and there are substantial strength differences between the N/A tranny and the turbo tranny.
You can run any RX-7 tranny on any RX-7 engine provided you mix and match the correct flywheel/counterweight,clutch and starter for the application you are putting together.There are minor differences in the shifter location and rear mount,and there are substantial strength differences between the N/A tranny and the turbo tranny.
Thread
Thread Starter
Forum
Replies
Last Post