Hey guys, I have searched the forums, FSM, Mazda parts catalog and Haynes manual to no avail.

Can someone please take a picture of where this oil cooler line bracket should go on a GSL-SE? Much appreciated!

 

It bolts on to middle iron just above oilpan. Originally the clamp that holds the oil line had a rubber grommet to keep line from chafing. You could probably slice a section of heater hose to go around line under clamp. The bracket bolts to engine clamp side up.
I,ll try to find a pic later tonight or tomorrow.

 

That goes on the center iron down low I believe It fits over an existing stud. There is a rubber piece that sits between the clamp and the oil line.

 

You guys are great! Thanks!

 

Hard to get a good pic

 

That's perfect! Thank you!