my first no start thread!
#1
Full Member
Thread Starter
Join Date: Jul 2005
Location: Asheville, NC
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
my first no start thread!
I've been gone for a while (the 7 has been running without any trouble and I've been to broke to even think about fun work), but the other day I was finally getting around to tightening up the throttle cable that has been lose since I removed the rat's nest and swapped the carb back over the summer. I thought everything had gone fine, the idle seemed to be better, it started up just fine, but the next day when I tried to start it up it was a no go.
it turns over just fine but won't fire. it's getting spark, fuel, compression seems good, even checked the air vent solenoid. I'm guessing that its flooding but I have pretty much no experience working on carbs so I'm trying to rule everything else out before I dive into that. any quick suggestions of something I might have bumped lose when tightening the throttle cable?
thanks ahead of time for any help.
it turns over just fine but won't fire. it's getting spark, fuel, compression seems good, even checked the air vent solenoid. I'm guessing that its flooding but I have pretty much no experience working on carbs so I'm trying to rule everything else out before I dive into that. any quick suggestions of something I might have bumped lose when tightening the throttle cable?
thanks ahead of time for any help.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM