my 12a project
#1
Senior Member
Thread Starter
Join Date: Apr 2007
Location: ottawa ks
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
my 12a project
is it posible to use the fuel injection intake off of a 13b on a 12a. also will a transmission from a 13b bolt to a 12a. i just got into a a rx-7 i always liked them but never worked on them so if any one has any suggestions on performance and stuff because i dont know much i always work on small block chevys and stuff and i thought about putting the 350 in it but i said no because i want the rotory.
any suggestions?
any suggestions?
#3
RX for fun
iTrader: (13)
you can buy an adapter plate from tweakit (IIRC) that will allow you to bolt up a FC/TII intake to a 12-A motor. At the same token, the LIM can be modded to fit all 4 injectors.
yes on the tranny except the TII's bellhousing must be changed to an old school so you can keep the stock 12-A clutch etc etc.
yes on the tranny except the TII's bellhousing must be changed to an old school so you can keep the stock 12-A clutch etc etc.
#4
Senior Member
Thread Starter
Join Date: Apr 2007
Location: ottawa ks
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
oh ok and the rear end out of the 13b has a limited slip will that bolt up to the 12a driveline if i dont use the 13b tranny
also should i keep it carburated and use an edelbrock 750 that i have
also should i keep it carburated and use an edelbrock 750 that i have
#6
Senior Member
Join Date: Dec 2005
Location: New Hampshire
Posts: 613
Likes: 0
Received 0 Likes
on
0 Posts
what gear is your car cause if your car is a gsl already has lsd on it , so to answer you question if your car has break rotors on the rear end it has an lsd on it.
Thread
Thread Starter
Forum
Replies
Last Post