MSD ?'s
#1
Junior Member
Thread Starter
Join Date: Apr 2001
Location: Lockney, TX, U.S.
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
MSD ?'s
When plugging in the MSD 6A into the ignitor on a 12A, which wires go where. Green to green, right? Then purple to the other side? Thanx
#4
Rotary Freak
iTrader: (6)
I have a wiring diagram for installing the MSD6AL, I think it would be the same. There are two wires coming out of the distributor that are red and green. These attach to the red and green wires of the MSD unit as follows (red to green and green to red). Ok, there are five more wires coming out of the other side of the MSD. Big red and black (go to the battery). Little red goes to a hot ignition wire. The orange and black that are together go to the 2nd gen coil (black to negative, orange to possessive). Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM