Lost my water temp guage
#1
Absolute Power is Awesome
Thread Starter
Lost my water temp guage
Driving around yesterday in my 82 I noticed that my water temperature guage wasn't reading, the needle is just dead at the bottom tick. My Haltech still reads the water temp correctly, so I know the sensor is working OK and all the other guages are working fine, so it's not the dash board. Has anyone else had the water temp guage die?
#3
Senior Member
Join Date: Oct 2002
Location: Eugene, Oregon
Posts: 501
Likes: 0
Received 0 Likes
on
0 Posts
The Bullet Connector ie Water Temp Sensor wire under the Oil Pedestal can get gunked up with Oil.
Pull it off and clean it up with Electric Cleaner or WD40 and Re-Connect it. You should be good to go.
Or it could just be loose.
Pull it anyhow to clean it up.
steve
sgieldon
Pull it off and clean it up with Electric Cleaner or WD40 and Re-Connect it. You should be good to go.
Or it could just be loose.
Pull it anyhow to clean it up.
steve
sgieldon
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM