idleing at 3k
idleing at 3k
my rx7 is idleing at 3k, this is what i did
I replaced the fuel injector O rings because my car was surging and having hot start problems.
when i put everything back together and started the car the rmps will stay at 3k and not go down, any ideas or mabie pics on what i can do will help
P.S this is a 1985 GSL-se 13B fuel injected
I replaced the fuel injector O rings because my car was surging and having hot start problems.
when i put everything back together and started the car the rmps will stay at 3k and not go down, any ideas or mabie pics on what i can do will help
P.S this is a 1985 GSL-se 13B fuel injected
Check the rubber hose coming off the back of the intake manifold same thing happend to me when i swapped out headers. just reconnect it to tha 6port accutuator tube if im not mistaken(pretty sure but ill check tomorrow) and the other side to the 3/4 alluminum nipple on the back of the manifold near where the lower and upper meet.
Check the rubber hose coming off the back of the intake manifold same thing happend to me when i swapped out headers. just reconnect it to tha 6port accutuator tube if im not mistaken(pretty sure but ill check tomorrow) and the other side to the 3/4 alluminum nipple on the back of the manifold near where the lower and upper meet.
i reconnected it and car runs fine thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM



