IDA mani for street 13B
#1
RIP Icemark
Thread Starter
iTrader: (4)
Join Date: Oct 2002
Location: Aloha OR
Posts: 1,481
Likes: 0
Received 0 Likes
on
0 Posts
IDA mani for street 13B
I asked this in the Rotary Performance section but didn't get a lot of replys so here it goes. I would like to get some feed back about running these on street cars.
Do the IDA's rather short runners kill the low end performace, I am assuming it will since I will have to get rid of my 5th/6th ports (this is a second gen).
Thanks
Do the IDA's rather short runners kill the low end performace, I am assuming it will since I will have to get rid of my 5th/6th ports (this is a second gen).
Thanks
#3
Absolute Power is Awesome
I've been running a 48IDA on my 13b street port with secondaries open. It's not a torquey engine by any means, but you can adjust the power band alot with jetting. On the setup I have above about 2000rpm is strong, above 5000 the thing really takes off. I'm not sure what it would feel like in a heavier 2nd gen, though.
Last edited by purple82; 08-16-03 at 10:42 AM.
Thread
Thread Starter
Forum
Replies
Last Post
turbo-minivan
General Rotary Tech Support
69
02-04-16 12:29 AM