hey guys so i plan on swapping out my pulley's for a new set. the problem i have is because of the age of my car. i cant find the red and yellow notches on the pulley because its rusted and pitted so bad.

allso iam getting a set of gilmer drive pulleys to replace them, does any one know how i can mark them at the right spots.

 

you need to search its been posted losts before wacky has evan posted pics on how to find tdc using the flywheel and a trannyu mounting hole

 

20seconds of lookin in the archives is all it took..


https://www.rx7club.com/1st-gen-archive-71/ignition-main-pully-timing-525909/

 

thanks for that link, my brother looked that up for me in all data i think.which would help if my pulleys had marks.i can do that to mark my pulley for the yellow mark.. wheat i need to figure out is how to mark the pulley for the red slot. sorry i didnt make that clear.

sorry if iam being confusing.