RX7Club.com - Mazda RX7 Forum

1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

how would one go about using gsl-se housings with 2nd gen irons?

   
Old May 16, 2008 | 04:33 PM
Share
  #1  
whereiscarmensandiego's Avatar
whereiscarmensandiego
Thread Starter
Rotary Enthusiast
 
Joined: Feb 2008
Posts: 900
Likes: 0
From: tennessee
how would one go about using gsl-se housings with 2nd gen irons?
i want to know because i want to use some gsl-se hosuings that are pp ported in my 2nd gen
Reply
0
Old May 16, 2008 | 04:55 PM
Share
  #2  
Jeezus's Avatar
Jeezus
Stu-Tron Get Yo Groove On
Tenured Member: 15 Years
iTrader: (5)
 
Joined: Nov 2006
Posts: 8,482
Likes: 31
From: Huntsville AL
You can't without machine work done. 1st gens have the gaskets in the housings, and the 2nd gens have the gaskets in the Irons.
Reply
0
Old May 16, 2008 | 08:42 PM
Share
  #3  
sleeper7's Avatar
sleeper7
Rotary Enthusiast
Tenured Member 15 Years
 
Joined: Aug 2006
Posts: 1,216
Likes: 10
From: Melbourne FL/San Antonio TX/Okinawa Japan
Use some "DEVCON" sealent on the FC plates and have them surfaced flat. I never tried it but did talke to someone who did with good results. It was a "drag car" though.

Also seen FC rotor housing used with SA plates. They used Indian head gasket sealer, again for drag racing only.

chuck
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
long time lurker first time poster
cristoDathird
Introduce yourself
28
May 30, 2019 08:47 PM
Porting templates for GSL-SE
wallyrx7
Rotary Car Performance
2
Aug 20, 2015 05:55 PM
Back to Subforum
1st Generation Specific (1979-1985)
View Next Unread
My new project; To4 FB...


Thread Tools
Search this Thread
Search this Thread:

Advanced Search

Advanced Search

All times are GMT -5. The time now is 08:27 AM.